Task 12-2: Perform A Walk Through; Task 12-3: Demonstrate Updated Customer Database; Task 12-4: Project Review - Lucent Technologies DEFINITY AUDIX Installation And Administration Manual

Installation and Switch Administration for G3i/G3s/G3vs/R5vs/R5si/ProLogix
Switches, TN2181 Emulation, Display Set Integration 585-300-122
10 Customer Acceptance
Perform a Walk Through
9. The Status field should display In service, idle . If it does not, see DEFINITY AUDIX
System — Maintenance , for information to correct the problem.
10. Continue with
Task 10-2: Perform a Walk Through
Perform a walk-through with the customer in which you do the following:
Show the customer the System-Parameters Customer-Options screen to
verify that the purchased ports and features are activated
Verify that the second blank magneto-optical disk is present
Verify that all DEFINITY AUDIX system documentation is present, and then
tell the customer how to use the documentation.
Provide the customer with a list of telephone numbers for technical
support.
Task 10-3: Demonstrate Updated
Customer Database
Show the customer the Test Alarm-Origination Short screen to verify that the
customer database is updated.
Task 10-4: Project Review
Conduct a project review according to current procedures.
T ask 10-2 .
NOTE:
Log in to the administration terminal as cust to display this screen.
NOTE:
The first is installed in the magneto-optical disk drive for system
backups.
Issue 1
May 1999
10-5