F: Set Switch-Link Parameters - Lucent Technologies DEFINITY AUDIX Installation And Administration Manual

Installation and Switch Administration for G3i/G3s/G3vs/R5vs/R5si/ProLogix
Switches, TN2181 Emulation, Display Set Integration 585-300-122
5 Initial Definity AUDIX Administration
Perform Initial DEFINITY AUDIX Administration
Task 5-1F: Set Switch-Link Parameters
Perform the following steps for DS integration:
1. With the cursor on the DEFINITY AUDIX command line, type change
switch-link and press
The system displays the "Switch Link Embedded" screen. This screen is
used to establish two conditions:
Figure 5-6. Switch-Link Embedded Screen
2. In the Host Switch field, type the switch number assigned to the switch
into which the AUDIX system is installed.
RETURN
Which AUDIX system is to be integrated into which switch
How a call is to be treated when the call answer timeout period
expires.
NOTE:
If you do not know the switch number, enter display dialplan at the
switch terminal. The Local Node Number field on the Dial Plan
screen displays the switch number.
.
Issue 1
May 1999
5-10