Changing Subscriber Stations; Checking The Switch Link - Lucent Technologies DEFINITY AUDIX Installation And Administration Manual

Installation and Switch Administration for G3i/G3s/G3vs/R5vs/R5si/ProLogix
Switches, TN2181 Emulation, Display Set Integration 585-300-122
I Changing Switch Integrations, Port Emulations, and Number of Voice Ports
Changing from DS Integration — Digital to CL Integration — Digital

Changing Subscriber Stations

1. Enter change station extension for each subscriber station.
2. Change the LWC Reception field to audix for each subscriber station if
the subscriber is storing Leave Word Calling messages on the DEFINITY
AUDIX system.
3. Set LWC Activation? to y if the subscriber is assigned the Leave Word
Calling feature.
4. Set Redirect Notification to y
5. Set Message Waiting Indication to led or neon if the voice terminal
has an MWI lamp. This step applies to 500, 2500, and 7104A voice
terminals only.
6. Under BUTTON ASSIGNMENTS, enter the following button assignments to
interact with DEFINITY AUDIX system features:
7. Press
Refer to Task 9-1
subscribers.

Checking the Switch Link

The switch link is the interface link assigned in
1. Enter busy link switch link number to busy out the switch link.
2. Enter test link switch link number to test the switch link.
3. Enter release link switch link number to release the switch link.
4. Enter status link switch link number to check the status of the switch
link.
in-service is displayed if the link is in service.
call-fwd
goto-cover
lwc-store
send-calls
.
ENTER
in Chapter 9 for further instructions on administering the
Chapter 4.
Issue 1
May 1999
I-12