Switch Carrier Configuration Worksheets - Lucent Technologies DEFINITY AUDIX Installation And Administration Manual

Installation and Switch Administration for G3i/G3s/G3vs/R5vs/R5si/ProLogix
Switches, TN2181 Emulation, Display Set Integration 585-300-122
A

Switch Carrier Configuration Worksheets

Switch Carrier Configuration
Worksheets
To install a DEFINITY AUDIX system in a System 75, DEFINITY, or ProLogix at a
customer site, the switch must have two
carrier. If the switch does not have two contiguous port slots available, the
system will have to be rearranged or a new carrier purchased.
NOTE:
Verify that the switch and switch software load can accommodate the
DEFINITY AUDIX system. See System Description (585-300-214) for the
load requirements of the DEFINITY AUDIX system.
Whoever is assigned the task of reconfiguring the circuit packs should complete
the following steps:
1. Complete
as port carrier or control carrier. In the remaining rows, write the circuit
pack currently occupying the indicated port slot. The total number of port
slots depends on the type of switch and function of the carrier.
2. Using the carrier configuration rules in the correct document for the
customer's switch, determine how two
obtained for the DEFINITY AUDIX system.
In reconfiguring the circuit packs use the following guidelines:
1. For the ProLogix, the DEFINITY AUDIX system only needs one slot if it is installed in slot 6.
Worksheet A-1. In the first row, indicate the type of carrier, such
For G3V2 or higher, use DEFINITY Communications System
Generic 3 System Description and Specifications , 555-230-201,
Issue 2 or higher.
For ProLogix R6 or higher, DEFINITY Enterprise Communications
Server Release 6 — System Description Pocket Reference ,
555-230-211, Issue 3 or higher.
Move as few packs as possible; look for a carrier that has one or
two contiguous port slots already available.
Consider the costs of testing once the carrier has been rearranged
(for example, tie trunks and DS1 packs are more expensive to test
than some other types of circuit packs).
1
contiguous port slots available in a
1
contiguous port slots can be
Issue 1
May 1999
A-1
A