Switch Names Audit - Lucent Technologies DEFINITY AUDIX Installation And Administration Manual

Installation and Switch Administration for G3i/G3s/G3vs/R5vs/R5si/ProLogix
Switches, TN2181 Emulation, Display Set Integration 585-300-122
5 Initial Definity AUDIX Administration
Check the Status of the Switch Names Audit
4. Press
The Message line displays the following message.
5. Press
If you are adding an unformatted MO disk, this step could take up to 10
minutes. You will verify the status of the add mo-disk function in
6. Continue with
Task 5-4: Check the Status of the

Switch Names Audit

The purpose of this task is to check the status of the switch names audit
operation initiated in
1. With the cursor on the DEFINITY AUDIX command line, enter status audit
and press
The system displays the Audit Results screen showing the result of the
most recently run audit.
(Enter).
F3
This operation erases all existing mo-disk data.
Press "ENTER" to confirm.
(Enter) to begin the add mo-disk function.
F3
T ask 5-4.
Task 5-1J.
.
RETURN
Issue 1
May 1999
5-21
Task 10-1.