Changing From Ds Integration - Digital To Cl Integration - Digital; Turning Off Message Waiting Indicators - Lucent Technologies DEFINITY AUDIX Installation And Administration Manual

Installation and Switch Administration for G3i/G3s/G3vs/R5vs/R5si/ProLogix
Switches, TN2181 Emulation, Display Set Integration 585-300-122
I Changing Switch Integrations, Port Emulations, and Number of Voice Ports
Changing from DS Integration — Digital to CL Integration — Digital
Changing from DS Integration —
Digital to CL Integration — Digital
This section describes the tasks needed to change the switch administration of
the DEFINITY AUDIX system to CL integration from DS integration.
NOTE:
To perform this procedure, you must refer to two versions of the DEFINITY
AUDIX installation book for your switch: the control-link version and the
display set version.

Turning Off Message Waiting Indicators

You must turn off the message waiting indicators (MWIs) on subscribers'
telephones before changing a system to CL integration. Otherwise, the indicators
will be on indefinitely, whether or not subscribers have new messages.
To turn off the MWIs, do the following:
1. At the switch administration terminal, enter change station extension for
the first voice port in the DEFINITY AUDIX hunt group.
The switch displays the Station screen.
2. Press
screen appears.
3. For feature button 1, replace lwc-store with lwc-cancel
4. For feature button 2, delete lwc-cancel
5. Press
6. Repeat Steps 1 through 5 for each voice port.
As the switch performs audits on the voice ports, it turns off subscriber
message waiting indicators. The switch requires approximately 15
seconds per subscriber to turn off the MWI. Therefore, you may have to
wait up to several hours for all indicators to be turned off.
7. Log into the DEFINITY AUDIX system.
8. On the DEFINITY AUDIX command line, enter display administration-log
The switch displays Page 1 of the Administration Log.
until the Feature Button Assignments page of the Station
NEXTPAGE
to save the changes.
ENTER
NOTE:
You do not have to wait until the MWI for each subscriber is turned
off before proceeding with the remaining steps.
Issue 1
May 1999
I-9