Task 9-2: Test The Call Answer And Voice Mail Features - Lucent Technologies DEFINITY AUDIX Installation And Administration Manual

Installation and Switch Administration for G3i/G3s/G3vs/R5vs/R5si/ProLogix
Switches, TN2181 Emulation, Display Set Integration 585-300-122
7 Joint Acceptance Testing
Test the Call Answer and Voice Mail Features
5. Press
6. Repeat Steps 2 through 5 for the second test subscriber.
7. If the system is running in a DCS environment, repeat Steps 2 through 5 for
one remote test subscriber on each switch in the DCS network.
8. Continue with
Task 7-2: Test the Call Answer and
Voice Mail Features
1. Create a test Call Answer message.
2. Retrieve the Call Answer message.
NOTE:
These are the only fields that you need to fill in. The system will use
defaults for the remaining fields.
(Enter) to add the test subscriber.
F3
NOTE:
Make sure that each DCS remote subscriber is assigned the correct
switch number. The switch number for DCS remote subscribers is
not the same as the host switch number. The Switch Number field on
the Subscriber screen must match the switch number for the
subscriber's switch on the Switch Link DCIU-SCI screen.
Task 7-2.
a. From one of the test telephones, call the extension of the second
test telephone.
b. Let the telephone ring until the DEFINITY AUDIX system answers.
c. After the system greeting and the tone, leave a test message, for
example, "This is a test Call Answer message."
d. Hang up.
a. Go to the telephone you just called, and check the message
waiting indicator. This is either a lamp on the telephone or a stutter
dial tone. (The MWI signal may take up to 1 minute to appear.) If the
MWI is on, Continue with
to the troubleshooting procedures in DEFINITY AUDIX System —
Maintenance , 585-300-121, to activate the MWI.
b. From telephone with the MWI on, call the DEFINITY AUDIX
extension.
c. After the DEFINITY AUDIX system answers and prompts you for
your extension, press
d. When the DEFINITY AUDIX system prompts you for your password,
press . There is no password assigned to this extension.
#
Step b. If the MWI does not activate, refer
.
#
Issue 1
May 1999
7-3