Task F-7: Install Definity Audix 4.0; Install Definity Audix 4.0; System Adaptor Cable - Lucent Technologies DEFINITY AUDIX Installation And Administration Manual

Installation and Switch Administration for G3i/G3s/G3vs/R5vs/R5si/ProLogix
Switches, TN2181 Emulation, Display Set Integration 585-300-122
F Migration Procedure

Install DEFINITY AUDIX 4.0

6. Disconnect the terminal, control link, LAN, alarm, and phone line cables
from both the alarm cable and the MFB cable.
7. Remove the existing alarm cable and MFB cable.
8. Continue with

Task F-7: Install DEFINITY AUDIX 4.0

1. Install the new system adaptor cable on the back of the switch.
Attach the male D-type amphenol connector on the new system adapter
cable to the slot previously occupied by the old DEFINITY AUDIX
multifunction board.
!
2. Reconnect all the peripheral hardware cables to the system adaptor
cable. See
3. Install the external modem for remote maintenance and alarms. See
2-2
system. This modem replaces the internal modem used by previous
versions of DEFINITY AUDIX.
4. Unpack the DEFINITY AUDIX 4.0 system.
Task F-7.
NOTE:
The new system has only adaptor cable that connects to the switch.
CAUTION:
You must connect the adapter cable directly to the port connector on
the switch. If you install another cable between the switch and the
cables, the DEFINITY AUDIX system will not operate correctly.
Table F-2 for the correct configuration.
Table F-2. System Adaptor Cable Connections
System Cable connector
Port A (Female RS-232)
Port B (Female RS-232)
Port C (Female RS-232)
Female RJ45
Amphenol
in Chapter 2 for instructions to connect it to the DEFINITY AUDIX
Hardware connection
Administration terminal
Control link or optional
terminal
External modem
LAN
Alarm connection
Continued on next page
Issue 1
May 1999
F-13
Task