G: Set System Parameters Limits - Lucent Technologies DEFINITY AUDIX Installation And Administration Manual

Installation and Switch Administration for G3i/G3s/G3vs/R5vs/R5si/ProLogix
Switches, TN2181 Emulation, Display Set Integration 585-300-122
5 Initial Definity AUDIX Administration
Perform Initial DEFINITY AUDIX Administration
3. In the AUDIX field, type the machine number of the AUDIX system being
installed.
4. In the Call Answer Timeout field, type the number of seconds the
system will wait for touch-tone digits when it answers a call without
receiving a "connect" message.
5. In the Call Answer Timeout field, type the way a call is to be handled
when the timeout period expires:
6. Finally, in the Extension field, type the number of the mailbox or
extension to which a call is to be transferred after it has timed out.
You may leave this field blank if you typed none in
7. Press
8. Proceed to
Task 5-1G: Set System Parameters Limits
This task is required only if the customer wants to use subscriber limits that are
different from the defaults. Check
change the system parameters limits. If not, determine the next step:
If I
NTUITY
If I
NTUITY
If changes are indicated on the worksheet, perform the following steps.
1. With the cursor on the DEFINITY AUDIX command line, type change
system-parameters limits and press
The system displays the System-Parameters Limits screen.
Enter none if the call is to be disconnected.
Enter mailbox if the call is to be transferred to a mailbox.
Enter transfer if the call is to be transferred to an extension.
(Enter) to save the changes.
F3
Task 5-1G.
Message Manager was purchased, continue with
Message Manager was not purchased, continue with
Worksheet C-5 to determine if you need to
.
RETURN
Issue 1
May 1999
5-11
Step 5.
Task 5-1H.
Task 5-1I.