Modem Option Settings (For Port C Modems; Us Robotics Sportster 33.6; Option Settings - Lucent Technologies DEFINITY AUDIX Installation And Administration Manual

Installation and Switch Administration for G3i/G3s/G3vs/R5vs/R5si/ProLogix
Switches, TN2181 Emulation, Display Set Integration 585-300-122
H Terminal and Modem Settings

Modem Option Settings (for Port C Modems)

For auxiliary printer options, set the options on the printer as described in the
manual supplied with the printer, then set the corresponding options on the
terminal to match.
Modem Option Settings (for Port C
Modems)
The DEFINITY AUDIX system supports external modems that use the Hayes
command set. This includes modems manufactured outside the United States.
This document describes the initialization settings for the following modems:

US Robotics Sportster 33.6

Paradyne Comsphere Models 3810 and 3820
Paradyne Comsphere Model 3910
Paradyne Comsphere Model 3910
7400A Data Module Settings
7400B Data Module Settings
If your modem is not listed, see
for a list of requirements and suggested modem settings.
!
CAUTION:
If you connect a modem to a DEFINITY AUDIX system installed in a
DC-powered switch, you must use a ground-isolated modem.
US Robotics Sportster 33.6
The US Robotics Sportster modems are shipped from the factory with default
option settings. Use the following procedure to change the settings when using
this modem with the DEFINITY AUDIX System.
1. Connect the modem to a terminal (for example, the 715 BCT) with the
terminal speed set at 96
2. Enter AT to get the OK prompt
3. Enter the following initialization string:
"Paradyne Comsphere Model 3910" on page H-6
øø
NOTE:
The maximum modulation data rate must be set to 9600 bps when this
modem is connected to DEFINITY AUDIX.
ø ø
AT&F &W
bps.
Issue 1
May 1999
H-5