Task 4-1: Install The Definity Audix System Assembly - Lucent Technologies DEFINITY AUDIX Installation And Administration Manual

Installation and Switch Administration for G3i/G3s/G3vs/R5vs/R5si/ProLogix
Switches, TN2181 Emulation, Display Set Integration 585-300-122
2 Hardware Installation
Install the DEFINITY AUDIX System Assembly
Worksheet E-1: Terminals
Task 2-1: Install the DEFINITY AUDIX
System Assembly
!
WARNING:
To prevent damage to the DEFINITY AUDIX system assembly, make sure
that you have connected the DEFINITY AUDIX system assembly adapter
cable to the port connector on the back of the switch (as described in
4 of the installation steps below) before you insert the DEFINITY AUDIX
system assembly in the switch carrier.
!
WARNING:
You can install the DEFINITY AUDIX system assembly in the switch when
the switch is powered either on or off. When the assembly is inserted in the
switch carrier, it automatically powers up, runs diagnostics, and boots. To
avoid a hard disk crash, never remove the assembly without first
completing the procedure to shut down the DEFINITY AUDIX system and
allowing the hard disk to completely spin down.
For the same reason, do not power cycle the switch (for example, during
switch acceptance tests) once the DEFINITY AUDIX system assembly is
inserted until you have shut down the DEFINITY AUDIX system. Refer to
Chapter 1 in DEFINITY AUDIX System — Maintenance, 585-300-121, for
the shutdown procedure.
NOTE:
The worksheets are included in appendices A-E. Refer to the
appendix corresponding to the worksheet letter. For example,
worksheet A-1 is in appendix A, worksheet C-10 is in appendix C,
etc.
NOTE:
If you are installing the system in a new switch purchased with
Definity Audix, the adaptor cables will already be installed.
Issue 1
May 1999
2-2
Step