Final Switch Administration: G3I/G3S/G3Vs/R5Vs/R5Si/Prologix; Task 11-1: Modifying The Station; Screen For Each Subscriber - Lucent Technologies DEFINITY AUDIX Installation And Administration Manual

Installation and Switch Administration for G3i/G3s/G3vs/R5vs/R5si/ProLogix
Switches, TN2181 Emulation, Display Set Integration 585-300-122
9

Final Switch Administration: G3i/G3s/G3vs/R5vs/R5si/ProLogix

Modifying the Station Screen for Each Subscriber
Final Switch Administration:
G3i/G3s/G3vs/R5vs/R5si/ProLogix
This chapter includes the final tasks required to administer DEFINITY AUDIX in
the host switch.
Task 9-1: Modifying the Station

Screen for Each Subscriber

Modify the station screen for each subscriber to complete the subscriber
administration.
At the switch administration terminal, modify the station screen for each
DEFINITY AUDIX subscriber as follows:
1. At the command prompt, enter change station extension
where extension is the extension of the voice port you want to modify.
2. Set Coverage Path to the subscriber coverage path defined in
in Chapter
Set LWC Reception to msa-spe.
3. Set LWC Activation? to n
4. Set Coverage Msg Retrieval? to y
5. Set Message Waiting Indicator? to led or neon if the voice terminal
has an MWI lamp. This applies to 500, 2500, and 7104A voice terminals
only.
6. Press
4.
NOTE:
We recommend that the switch Leave Word Calling (LWC) feature
not be activated for any voice terminals other than the DEFINITY
AUDIX voice ports since this will cause a problem when clearing
message waiting indicator lamps (MWIs). We recommend you do
not assign a LWC button to any subscriber. Thus, avoid using the
code lwc-store for any button.
to save the changes.
ENTER
Issue 1
May 1999
9-1
9
Task 4-4