Task 7-2: Activate Parameters And Basic Features - Lucent Technologies DEFINITY AUDIX Installation And Administration Manual

Installation and Switch Administration for G3i/G3s/G3vs/R5vs/R5si/ProLogix
Switches, TN2181 Emulation, Display Set Integration 585-300-122
5 Initial Definity AUDIX Administration
Activate Parameters and Basic Features
4. Because of the possible long duration of this task, complete the remaining
administration tasks and then check the status of this audit as described
in Task
5. Continue with
Task 5-2: Activate Parameters and
Basic Features
This task is required if the customer indicates specific features to be activated.
Check Worksheet C-7
to be activated, skip to
1. With the cursor on the DEFINITY AUDIX command line, type change
system-parameters features and press
The system displays the System-Parameters Features screen
Figure 5-11. System-Parameters Features Screen
2. Move the cursor to any of the fields to be changed on the first page. Use
the information on
5-4.
Task 5-2.
to see if any features are to be activated. If no features are
Task 5-3.
Worksheet C-7
.
RETURN
to type the values specified.
Issue 1
May 1999
5-17