Removing Existing Voice Ports - Lucent Technologies DEFINITY AUDIX Installation And Administration Manual

Installation and Switch Administration for G3i/G3s/G3vs/R5vs/R5si/ProLogix
Switches, TN2181 Emulation, Display Set Integration 585-300-122
I Changing Switch Integrations, Port Emulations, and Number of Voice Ports
Changing from CL Integration — Analog to DS Integration — Digital
2. Record the extension and port numbers for each port. Note also if the
ports are digital or analog. The following port types are all analog:
3. Determine your next step:

Removing Existing Voice Ports

Use the following procedure to remove the voice ports from both the hunt group
and from the switch.
1. Enter list hunt-group to locate the DEFINITY AUDIX system hunt group.
The figure below shows the DEFINITY AUDIX hunt group listed for a switch
identified by the Group Name AUDIX.
list hunt-group
Grp Grp Type
No. Ext.
10 12000 ucd
Figure I-2. Example of a Voice Port Hunt Group screen
2. Enter change hunt-group number where number is the hunt group
number.
2500 (System 75, G1, G3V1, and G3i-Global)
ADXCL (G3V2/V3/V4/R5/R6)
ADX16A (R7 or greater)
If the ports are analog, continue with
Ports''.
If the ports are digital, continue with
page I-6 .
HUNT GROUP
Group Name ACD
AUDIX n
''Removing Existing Voice
''Verifying the Circuit Pack''
MIS Queue No. of
Length Members
n 12 12
Issue 1
May 1999
I-5
on
Page 1
Covg. Message
Path Center