Migration Procedure - Lucent Technologies DEFINITY AUDIX Installation And Administration Manual

Installation and Switch Administration for G3i/G3s/G3vs/R5vs/R5si/ProLogix
Switches, TN2181 Emulation, Display Set Integration 585-300-122
F

Migration Procedure

Migration Procedure
A customer with DEFINITY® AUDIX® 3.2 or earlier can migrate to DEFINITY
AUDIX version 4.0 from either Control Link (CL) integration or Display Set (DS)
integration. In either case, DEFINITY AUDIX 4.0 connects to the existing
hardware via a new system adaptor cable, and in most cases, only minor
changes need to be administered to the switch and the DEFINITY AUDIX system.
DEFINITY AUDIX 4.0 supports a maximum of 12 voice ports with no networking
port, or 8 voice ports with 1 networking port. If the existing system includes any
of the following configurations, the system must either be upgraded to an Intuity
Audix or modified to eliminate excess voice ports and networking ports:
2 networking ports
1 networking port with more than 8 voice ports
No networking ports and more than 12 voice ports
When you migrate data from the existing system, however, you must administer
changes to the DEFINITY AUDIX voice group and to the voice ports on the
switch.
This migration procedure requires that the TN568 circuit pack of the DEFINITY
AUDIX 4.0 system be installed in the same slot that was occupied by the
previous DEFINITY AUDIX system. If DEFINITY AUDIX 4.0 is installed in a
different slot, contact the remote service center.
!
CAUTION:
Migrating DEFINITY AUDIX data from an existing system to a new
system overwrites any existing data on the new system, including
any data previously migrated.
Issue 1
May 1999
F-1
F