Add Voice Ports Back To The Hunt Group - Lucent Technologies DEFINITY AUDIX Installation And Administration Manual

Installation and Switch Administration for G3i/G3s/G3vs/R5vs/R5si/ProLogix
Switches, TN2181 Emulation, Display Set Integration 585-300-122
F Migration Procedure
Administer Changes to the Switch
12-port emulation:
5. Press
6. Continue with
Task F-11B3: Delete the Voice Ports
If you migrated to a system that has fewer voice ports than the old system, you
must delete the station entries of the excess voice ports.For instance, if the old
system has 16 ports, and the new one has 12, you must delete the stations for
ports 13 through 16.
To delete the voice ports:
1. At the switch administration terminal, enter remove station number
where number is the extension of the voice port you want to delete.
The switch displays the station screen for this port.
2. Review the station screen to ensure it corresponds to the voice port you
want to remove.
3. If this is the correct voice port, press
The switch displays the following message:
4. Repeat
group.
5. Repeat steps 1 through 5 for the other voice ports you need to change.
6. Continue with
Task F-11C: Add Voice Ports Back to the Hunt
Group
Add the voice ports purchased for the system back into the DEFINITY AUDIX
Hunt Group.
a. Set the first nine BUTTON ASSIGNMENTS to call-appr
b. Set the tenth BUTTON ASSIGNMENTS to bridg-appr XXXX
where XXXX equals the extension number of voice port 8.
For ports 1 through 4 and port 12, set all ten BUTTON
ASSIGNMENTS to call-appr
For ports 5 through 11, do the following:
a. Set the first nine BUTTON ASSIGNMENTS to call-appr
b. Set the tenth BUTTON ASSIGNMENTS to bridg-appr XXXX
where XXXX equals the extension number of voice port 12.
to save the Station screen changes.
ENTER
Task F-11B3.
command successfully completed.
Task F-11B3 to delete other voice ports you removed from the hunt
Task F-11C.
.
ENTER
Issue 1
May 1999
F-27