Installing Additional Language Sets - Lucent Technologies DEFINITY AUDIX Installation And Administration Manual

Installation and Switch Administration for G3i/G3s/G3vs/R5vs/R5si/ProLogix
Switches, TN2181 Emulation, Display Set Integration 585-300-122
G Announcement Set Considerations and Installation

Installing Additional Language Sets

Installing Additional Language Sets
Perform the following procedure to add new language sets while restoring a
DEFINITY AUDIX system. Each language set is provided on its own
magneto-optical disk cartridge.
1. Inform subscribers through a broadcast message that the DEFINITY
AUDIX system will be taken off the line for up to half an hour.
2. Log in to the DEFINITY AUDIX System on the administration terminal as
craft .
3. Enter reset system oa&m
Use the camp-on option to allow any callers to complete their messages.
The system resets to the Operations, Administration, and Maintenance
(OA&M) state.
4. Press
The system stops all calls and the cursor returns to the DEFINITY AUDIX
login prompt.
5. Login as craft .
6. Enter remove mo-disk
7. Remove the magneto-optical disk cartridge from the MO-drive and insert
the new language disk cartridge.
8. Enter add mo-disk
The add operation takes approximately 15 seconds and is done in the
background. When the operation is complete, the Status Disk screen will
show In service, idle.
9. Enter restore backups
The system restores the new language set from the magneto-optical disk
cartridge.
10. Press
11. Enter remove mo-disk
12. If more than one language set is being added to the system, repeat
through
13. Remove the new language disk cartridge and insert the original backup
disk cartridge.
14. Enter reset system restart
15. The system reboots and returns to the AUDIX state.
(Enter).
F3
to confirm this operation.
RETURN
Step 11 with each new language disk cartridge.
Issue 1
May 1999
G-3
Step 6