Installation Steps - Lucent Technologies DEFINITY AUDIX Installation And Upgrade

Task 5: Install the DEFINITY AUDIX System Assembly
20 19 18 17
Figure 2-2. Connecting the Adaptor Cables Rear-Panel View
If the DEFINITY AUDIX system was shipped in a new switch, skip to Step 7 of this
task.

Installation Steps

Using Worksheet A-3, Port Slot Locations for the DEFINITY AUDIX System
Assembly , follow the steps below to install the DEFINITY AUDIX system
assembly.
1. Remove the amphenol connectors from the third and fourth slots of the five
(four for G3vs) contiguous slots reserved for the DEFINITY AUDIX system.
For example, if you are to install the DEFINITY AUDIX system in slots 7
through 11 of carrier A in the switch, remove the amphenol connectors on
the Group 300 cables from slots 9 and 10. (These are the two slots that
provide connectivity to the DEFINITY AUDIX system circuit packs.)
2. Dress down the cable you removed from the 4th slot to the wall field. (Do
not dress down the cable from the 3rd slot, you will use it in the next task to
cable the alarm origination.)
5th
16 15 14 13 12 11
MFB
Y-CABLE
(H600-352-G1)
FEMALE FEMALE
RS-232 RS-232
EXAMPLE OF
DEFINITY AUDIX
SLOTS
4th 3rd 2nd 1st
10 9 8 7 6 5
ALB
CABLE
(H600-353 G2)
AMPHENOL
CONNECTOR
FEMALE FEMALE
RS-232 RJ45
Issue 2 December 1996
4 3 2 1
2-5