Task 22: Test The Call Answer And Voice Mail Features - Lucent Technologies DEFINITY AUDIX Installation And Upgrade

Acceptance Checks
7. If running in a DCS environment, repeat Steps 2 through 5 for one test
subscriber on each switch in the DCS network.
NOTE:
Make sure that each DCS remote subscriber is assigned the correct
switch number. The switch number for DCS remote subscribers is
not the same as the host switch number. The Switch Number field on
the Subscriber screen must match the switch number for the
subscriber's switch on the Switch Link DCIU-SCI screen (see Task
14E).
8. Proceed to Task 22: Test the Call Answer and Voice Mail Features.
Task 22: Test the Call Answer and
Voice Mail Features
This task is required for all installation scenarios.
1. Create a test Call Answer message.
a. From one of the test phones, call the extension of the second test
b. Let the phone ring until the DEFINITY AUDIX system answers.
c. After the system greeting and the tone, leave a test message (for
d. Hang up.
2. Retrieve the Call Answer message.
a. Walk over to the phone that you just called and check the message
b. From this phone (the one with the MWI on), call the DEFINITY
c. After the DEFINITY AUDIX system answers and prompts you for
d. When the DEFINITY AUDIX system prompts you for your password,
e. If the Name Record by Subscriber feature is on, the DEFINITY
4-10
Issue 2 December 1996
phone.
example, "This is a test Call Answer message."
waiting indicator — either a lamp on the phone or a stutter dial tone.
(The MWI signal may take up to 1 minute to appear.) If it is on,
proceed to the next step. Otherwise, refer to the troubleshooting
procedures in DEFINITY AUDIX System — Maintenance ,
585-300-110.
AUDIX extension.
your extension, press
#
press (the pound sign). There is no password assigned to this
#
extension.
AUDIX system will prompt you to record a name. Record a test
name such as "test name."
(the pound sign).