Subtask 14K: Run The Switch Names Audit - Lucent Technologies DEFINITY AUDIX Installation And Upgrade

Initial System Administration

Subtask 14K: Run the Switch Names Audit

This task is required only if the system uses DS integration. Otherwise, skip to
Task 14L: Check Alarm Status.
The Switch Names audit uploads the names-to-extensions database from the
switch. The Switch Names audit could take from 5 minutes to an hour, depending
on the size of the database.
1. With the cursor on the DEFINITY AUDIX command line, type audit
switch-names and press
The system displays the Switch Names Audit screen.
2. Press the
3. Press the
background.
NOTE:
Because of the possible long duration of this task, complete the
remaining administration tasks (Task 14L: Check Alarm Status, Task
14M: Check Hardware Status, Task 16: Add Tape, and Task 17:
Check the Status of the Switch Names Audit) and then check the
status of this audit as described in Task 17: Check the Status of the
Switch Names Audit.
4. Proceed to Task 14L: Check Alarm Status.
3-26
Issue 2 December 1996
.
RETURN
(F3) function key to begin the audit.
ENTER
(F3) function key again to have the audit run in the
ENTER