Task 14G: Set System Parameters Limits - Lucent Technologies DEFINITY AUDIX Installation And Upgrade

Task 14: Perform Initial DEFINITY AUDIX Administration
The system displays the Date And Time screen.
2. With the cursor at the Synchronize to Switch field, type y.
3. Press the
4. Proceed to Task 14G: Set System Parameters Limits.

Task 14G: Set System Parameters Limits

This task is required only if the customer wants to use subscriber limits that are
different from the defaults. Check Worksheet C-4, Set System Parameters Limits ,
to see if you need to change the system parameters limits. If not, skip to Task
14H: Run the Switch Translations Audit a Second Time. If changes are indicated
on the worksheet, perform the following steps.
1. With the cursor on the DEFINITY AUDIX command line, type change
system-parameters limits and press
(F3) function key to save the changes.
ENTER
.
RETURN
Issue 2 December 1996
3-21