Authentication Server - ZyXEL Communications ZyWall 110 User Manual

36.12 Authentication Server

You can set the ZyWALL/USG to work as a RADIUS server to exchange messages with a RADIUS
client, such as an AP for user authentication and authorization. Click Configuration > System >
Auth. Server tab. The screen appears as shown. Use this screen to enable the authentication
server feature of the ZyWALL/USG and specify the RADIUS client's IP address.
Figure 491 Configuration > System > Auth. Server
The following table describes the labels in this screen.
Table 315 Configuration > System > Auth. Server
LABEL
Enable
Authentication
Server
Authentication
Server
Certificate
Authentication
Method
Trusted Client
Add
Edit
Remove
Activate
Inactivate
#
Status
Profile Name
Chapter 36 System
DESCRIPTION
Select the check box to have the ZyWALL/USG act as a RADIUS server.
Select the certificate whose corresponding private key is to be used to identify the
ZyWALL/USG to the RADIUS client. You must have certificates already configured in the My
Certificates screen.
Select an authentication method if you have created any in the Configuration > Object >
Auth. Method screen.
Use this section to configure trusted clients in the ZyWALL/USG RADIUS server database.
Click this to create a new entry. Select an entry and click Add to create a new entry after
the selected entry.
Double-click an entry or select it and click Edit to be able to modify the entry's settings.
To remove an entry, select it and click Remove. The ZyWALL/USG confirms you want to
remove it before doing so. Note that subsequent entries move up by one when you take
this action.
To turn on an entry, select it and click Activate.
To turn off an entry, select it and click Inactivate.
This is the index number of the entry.
This icon is lit when the entry is active and dimmed when the entry is inactive.
This field indicates the name assigned to the profile.
ZyWALL/USG Series User's Guide
702