Bridge Add/Edit - ZyXEL Communications USG40 User Manual

Zywall/usg series

Hide thumbs Also See for USG40:

Table of Contents

Table 117 Configuration > Network > Interface > Bridge (continued)

Object References

10.8.2 Bridge Add/Edit

This screen lets you configure IP address assignment, interface bandwidth parameters, DHCP

settings, and connectivity check for each bridge interface. To access this screen, click the Add or

Edit icon in the Bridge Summary screen. The following screen appears.

Chapter 10 Interfaces

Select an entry and click Object Reference to open a screen that shows which

settings use the entry. See

This field is a sequential value, and it is not associated with any interface.

This icon is lit when the entry is active and dimmed when the entry is inactive.

This field displays the name of the interface.

This field displays the current IP address of the interface. If the IP address is 0.0.0.0,

the interface does not have an IP address yet.

This screen also shows whether the IP address is a static IP address (STATIC) or

dynamically assigned (DHCP). IP addresses are always static in virtual interfaces.

This field displays the Ethernet interfaces and VLAN interfaces in the bridge interface. It

is blank for virtual interfaces.

Click Apply to save your changes back to the ZyWALL/USG.

Click Reset to return the screen to its last-saved settings.

ZyWALL/USG Series User's Guide

Section 10.3.4 on page 286

for an example.

Show Quick Links

Table of Contents