Ip Igmp Querier-Timeout; Ip Igmp Query-Interval - Dell Force10 Z9000 Reference Manual

ip igmp querier-timeout

Change the interval that must pass before a multicast router decides that there is no longer another multicast router that
should be the querier.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip igmp querier-timeout seconds
To return to the default value, use the no ip igmp querier-timeout command.
Parameters
seconds
Defaults 125 seconds
Command Modes INTERFACE
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command.

ip igmp query-interval

Change the transmission frequency of IGMP general queries sent by the Querier.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip igmp query-interval seconds
To return to the default values, use the no ip igmp query-interval command.
Parameters
seconds
Defaults 60 seconds
Command Modes INTERFACE
672
Enter the number of seconds the router must wait to become the new
querier. The range is 60 to 300. The default is 125 seconds.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the S-Series in Interface VLAN mode only to enable the
system to act as an IGMP Proxy Querier.
Introduced on the C-Series in Interface VLAN mode only to enable the
system to act as an IGMP Proxy Querier.
Enter the number of seconds between queries sent out. The range is
1 to 18000. The default is 60 seconds.