Calibrating Sensor Head - Omron ZW-C1*AT User Manual

Calibrating Sensor Head

Calibrating Sensor Head p.42
Operating procedure
Steps Key operation
1
2
3
4
5
Important
When Sensor Head calibration fails
If the Sensor Head is calibrated in an inappropriate environment, an error is displayed on the main display. If this
happens, press the
calibrating the Sensor Head in an appropriate environment, the fiber connector on the Sensor Head or Sensor
Controller may be stained. Clean the fiber cable or fiber connector referring to p.39.
336
Setting the System
Display Description
Press and hold the
(For details on the functions of the Mode switching key, see p.294.)
Press the
Press the
"OK/CAN" is displayed on the sub-display.
Press the
Press the
key
to return to the previous screen and try again. If an error continues even after
key for two seconds to enter the FUN mode.
/ keys to select "SYSTEM" and press the
/ keys to select "H.CALIB", then press the
key to execute calibration or the
key for two seconds to enter the RUN mode.
key.
key.
key to cancel.
ZW User's Manual