Omron ZW-C1*AT User Manual page 318

Performing 2-point Scaling
Performing 2-point Scaling p.90
Operating procedure
Steps Key operation
1 to 6 For moving to "SCALE" - "AUTO", see steps 1 to 6 in p.314.
7
8
9
10
11
12
13
316
Setting the Output Conditions
Display Description
Press the
Press the
Set the measured value of point 1.
The current measured value is displayed on the main display and the
current setting value is displayed on the sub-display.
To edit numerical values, use the
Enter the setting value and then press the
Press the
Set the measured value of point 2.
To edit numerical values, use the
Enter the setting value and then press the
"OK/CAN" is displayed on the sub-display.
Press the
Press the
/ keys to select "2PT" and press the
key when the main display shows "POINT1".
/ /
key when the main display shows "POINT2".
/ /
key to execute scaling or
key for two seconds to enter the RUN mode.
key.
/ keys.
key.
/ keys.
key.
key to cancel.
ZW User's Manual