Omron ZW-C1*AT User Manual page 281

Event name RESET input error
Meaning RESET input processing was not executed correctly.
Source EtherCAT master function module
Error attributes Level
Effects User program
Indicators EtherCAT NET RUN

System-defined Variable
variables
None
Cause and Assumed cause
correction
RESETx input turned ON in the
FUN mode.
Attached None
information
Precautions/ None
Remarks
Event name ZERO input error
Meaning ZERO input processing was not executed correctly.
Source EtherCAT master function module
Error attributes Level
Effects User program
Indicators EtherCAT NET RUN

System-defined Variable
variables
None
Cause and Assumed cause
correction
ZEROx input turned ON in the FUN
mode.
ZEROx input turned ON in a non-
measurement state.
ZEROx input turned ON for a task
whose status is OFF.
Attached None
information
Precautions/ None
Remarks
ZW User's Manual
Source details
Minor fault Recovery
Continues Operation
EtherCAT NET ERR

Data type

Correction
Switch to the RUN mode, and turn
RESETx input ON.
Source details
Minor fault Recovery
Continues Operation
EtherCAT NET ERR

Data type

Correction
Switch to the RUN mode, and turn
ZEROx input ON.
Modify the program so that ZEROx
input turns ON when the sensor is
ready for measurement.
Modify the program so that the task
that turns ZEROx input ON turns
the status ON.
Event code 7494 0000Hex
Slave Detection
timing
Error reset Log category
(after
cancellation of
slave error)
RESET input processing is not executed.
EtherCAT LINK/ACT

Name

Prevention

Event code 7495 0000Hex
Slave Detection
timing
Error reset Log category
(after
cancellation of
slave error)
ZERO input processing is not executed.
EtherCAT LINK/ACT

Name

Prevention

Program so that ZEROx input turns
ON when the sensor is ready for
measurement.
Program so that the task that turns
ZEROx input ON turns the status
ON.
When instructed
by the user
System
When instructed
by the user
System
279
Error Messages