Table of Contents
Advertisement
Steps
Key operation
5
6
7
8
9
10
11
12
13
340
Connecting Parallel I/O
Display
Description
Select monitor focus ON/OFF.
The current setting value is displayed on the sub-display.
Press
In this example, select "ON" and press the
Set the distance value of the 1st point.
The current setting value is displayed on the sub-display.
Press
In this example, select "4mA" and press the
Set the output value of the 1st point.
The current setting value is displayed on the sub-display.
Press
To edit numerical values, use the
In this example, input "0", then press the
The decimal point is displayed.
Press the
Determine the decimal point and then press the
Set the distance value of the 2nd point.
The current setting value is displayed on the sub-display.
Press
In this example, select "20mA" and press the
Set the output value of the 2nd point.
The current setting value is displayed on the sub-display.
Press
To edit numerical values, use the
In this example, input "6", then press the
The decimal point is displayed.
Press the
Determine the decimal point and then press the
"OK/CAN" is displayed on the sub-display.
Press the
Press the
/
key to enter editing mode and the sub-display blinks.
/
key to enter editing mode and the sub-display blinks.
key to enter the editing mode, and the sub-display blinks.
/
/
/
key to move the decimal point.
/
key to enter editing mode and the sub-display blinks.
key to enter the editing mode, and the sub-display blinks.
/
/
/
key to move the decimal point.
key to reflect the settings or the
key for two seconds to enter the RUN mode.
key.
key.
/
keys.
key.
key.
key.
/
keys.
key.
key.
key to cancel.
ZW User's Manual
Advertisement
Table of Contents
Troubleshooting
