Setting the Clamp Value
Setting the Clamp Value p.149
As an example, the following explains the procedure for setting the clamp value to "analog voltage output 10V".
Operating procedure
Steps
Key operation
1 to 4
For moving to "HLD.RST" - "CLAMP", see steps 1 to 4 in p.344.
2
6
7
ZW User's Manual
Display
Description
Press the
Set the clamp value.
The current setting value is displayed on the sub-display.
Press
Select "10V" and press the
Press the
/
keys to select "ANALOG" and press the
/
key to enter editing mode and the sub-display blinks.
key.
key for two seconds to enter the RUN mode.
key.
Connecting Parallel I/O
345