Omron ZW-C1*AT User Manual page 123

3
Select data to monitor the trend for.
Set data to monitor the trend for.
The types of data that can be set are as follows.
Item
Target data
4
Set the logging sampling interval.
Set the logging sampling interval for the target data.
Item
Sampling setting
5
Click the Start icon (
When the sampling starts, the sampled data is displayed in the graph.
Note
You can also specify the timing (start trigger, end trigger) for the graph display.
6
Click the End icon (
When the sampling ends, the graph display stops too.
ZW User's Manual
Setting item Description
TASK1 TASK1 measurement results
TASK2 TASK2 measurement results
TASK3 TASK3 measurement results
TASK4 TASK4 measurement results
TIMING TIMING input signal (parallel I/O)
ZERO ZERO input signal (parallel I/O)
BUSY BUSY output signal (parallel I/O)
ENABLE ENABLE output signal (parallel I/O)
HIGH HIGH output signal (parallel I/O)
PASS PASS output signal (parallel I/O)
LOW LOW output signal (parallel I/O)
Setting item Range
Data interval 0 to 65535
) to start the sampling.
) to end the sampling.
Description
Set the sampling interval for the target data.
Displaying measured values in graphs
121