Setting For Serial Data Output After Application Of Measured Value - Omron ZW-C1*AT User Manual

Setting for serial data output after application of measured value

When hold is set, the applied measured data can be output automatically.
Data that can be output
The data to be output is measured values applied at the time that the output cause occurs.
The data to be output is fixed to four tasks, TASK1 to TASK4, and can not be set individually.
Timing for outputting data
When hold (peak, bottom, peak-to-peak, average, sampling) is set, the measured value data is output when a
measured value is applied for even one of the four tasks. For the trigger method, both timing input from the
outside and self-triggering are supported.
Setting the data output destination
Serial data can be output from Ethernet or RS-232C. This section describes the procedure for the setting.
Item Setting item
Data output set- Data output
tings destination
 Explorer pane
 Edit pane
ZW User's Manual
Description
Sets the interface for serial data output.
: [System] (double-click)
: [Data output settings] icon (
Range
OFF (default value)/Ethernet/RS-232C
)
No-protocol Connection
231