Rear View - Omron ZW-C1*AT User Manual

● Connectors/terminals
No. Names
21 RS-232C connector
22 Ethernet connector
23 EtherCAT input connector
24 EtherCAT input output connector This connector is used to connect to EtherCAT-compatible devices.
25 24 V input terminal block
26 32-pole extension connector
27 Analog output terminal block
28 Fiber connector
29 ROM connector
30 Frame ground terminal

Rear view

No. Names
31 DIN track attachment hook
Bottom view
No. Names
32 Installation screw hole
28
Part Names and Functions
Functions
Connect the RS-232C cable when you are connecting the system with a PLC or personal
computer through RS-232C.
For the RS-232C cable, please use the following exclusive products:
If you use a cable not included in the exclusive products, a false operation or breakdown
may result.
• For connecting to a PLC or programmable terminal: ZW-XPT2
• For connecting to a PC: ZW-XRS2
This connector is used to connect with a personal computer through Ethernet.
Prepare commercially available Ethernet cable satisfying the following requirements:
• Category 5e or more, 30 m or less
• RJ45 connector (8-pin modular jack)
• For one-to-one connection: Select cross cable.
• For connection through an industrial switching hub: Select straight cable.
(Recommended hub: W4S1-0@ (Omron))
This connector is used to connect to EtherCAT-compatible devices.
Use the recommended EtherCAT cable.
Use the recommended EtherCAT cable.
This connector is used to connect to Sensor Controller DC24 V power supply. The length
of Cables should be less than 30 m.
This connector connects the parallel I/Os, including output for judgment, ALARM, BUSY
or ENABLE, or input for ZERO, RESET, TIMING, LED-OFF or LOGGING, or bank num-
ber output and bank number selection input.
This connector connects the output for analog voltage and analog current. The length of
Cables should be less than 30 m.
The fiber connector connects the fiber cable.
The ROM connector connects the calibration ROM.
This is the connector for frame ground. It connects grounding wire.
Functions
Used when fixing the Sensor Controller on DIN track.
Functions
Used when fixing the Sensor Controller with screws.
ZW User's Manual