Omron ZW-C1*AT User Manual page 106

Setting a Trigger Delay
Set this to ignore measure values following TIMING input to avoid the influence of bounding or mechanical
vibration when a device is started up.
The delay time (the delay between timing input and the start of sampling) and the sampling time can be set.
TIMING input
Sampling period
Measured value
Item Setting item
Trigger delay Trigger delay mode
Delay time
Sampling time
 Explorer pane
 Edit pane
 Task Settings window : [Hold]
1
Set the hold mode and trigger.
Setting the Hold Mode p.98
Setting Triggers p.101
2
Select ON/OFF from [Trigger delay] - [Trigger
delay mode].
3
Enter [Delay time] and [Sampling time].
Important
Set so that the "delay time + sampling time" is
shorter than the TIMING input interval. When the
TIMING input turns ON again before the "delay
time + sampling time" elapses, the TIMING input
that is input later is ignored and is not reflected in
sampling.
Note
The trigger delay can also be set by the operating keys on the Sensor Controller.
Setting a Trigger Delay p.321
104
Setting the Output Conditions
ON
OFF
Delay time
Measured values in this time period
is included in the sampling.
Setting value
OFF (default value)/ON
1 (default value) to 5,000
[ms]
1 to 5,000 [ms]
(default value: 100ms)
: [Bank] | [(Bank Data Name)] (double click)
: [Task Settings] icon (
Sampling time
Description
Turns the trigger delay ON/OFF.
Set the time from TIMING input ON up to start of sampling.
Set to period during which sampling is to be performed.
)
ZW User's Manual