Boot Run Procedure - Mitsubishi Q00JCPU User Manual

12
PROCEDURE FOR WRITING PROGRAM TO CPU
MODULE

12.2.5 Boot run procedure

This section explains a boot run procedure.
In the following procedure,
indicates that on the High Performance model QCPU, Process CPU, Redundant CPU or
Universal model QCPU side.
12.2 High Performance Model QCPU, Process CPU, Redundant CPU, Universal Model QCPU
Start (Continued from
Section 12.2.3, 12.2.4
Se ction 11.2.3,11.2. 4)
When the RUN/STOPT switch is in the
RUN position, set the switch to the
STOP position.
In the boot file setting of the PLC
parameter dialog box, set the parameter,
program, device initial value and device
comment file names to be read from the
standard ROM or memory card.
In the program setting of the PLC
parameter dialog box, set the program
names to be executed and their execution
conditions (they must also be set if one
program is to be executed).
Set the parameter-valid drive of the DIP
switches (SW2, SW3).
Use the standard
NO
RAM or memory card
(except Flash card)?
YES
Choose [Online] [Format PLC memory]
on GX Developer, and format the
memory.
Choose [Online] [Write to PLC (Flash
ROM)] [Write to PLC (Flash ROM)] on
GX Developer, and write data to the
memory set as the "transfer source" in
the boot file setting.
Power the PLC OFF and then ON, or
reset the CPU module.
NO
Is the BOOT
LED on?
YES
End
* 1 : Refer to the following manual for the procedure when the Redundant CPU is used.
QnPRHCPU User's Manual (Redundant System)
* 2 : RUN/STOP/RESET switch for the Universal model QCPU.
* 3 : The parameter-valid drive setting by the DIP switch is not necessary for the Universal model
QCPU. ( Section 5.2.11)
* 4 : The Universal model QCPU cannot boot data from the standard ROM to program memory.
( Section 5.2.3).
Figure 12.7 Boot run flowchart
indicates the operation on the GX Developer side, and
2
4
Section 5.2.9
Section 3.3.6
3
Part names and settings of QCPU User's Manual
(Hardware Design, Maintenance and Inspection)
GX Developer Operating Manual
Section 5.2.6
1
12.2.5 Boot run procedure
9
10
11
12
12
- 18