Mitsubishi Q00JCPU User Manual page 368

6
FUNCTIONS
(4) Operation method
No.
1)
2)
3)
4)
5)
6)
7)
6
- 68 6.11 Monitor Function
6.11.4 Executional conditioned device test
(a) Registering executional conditioned device test settings
Select the registration target step number on the program editing screen in GX
Developer. Then, select [Online]
test] [Register executional conditioned device test].
3)
5)
1)
2)
4)
Figure 6.42 Screen for registering executional conditioned device test settings
Table6.23 Items on the screen for registering executional conditioned device test settings
Item
For bit device
Program name
Step No.
Device
Execution timing
Setting value - (Not specified)
DEC / HEX - (Not specified)
*1
- (Not specified)
Value format
* 1 : When a word device which is index-modified or indirectly-specified is set, only "16 bit integer" can
be specified.
1) Multiple executional conditioned device test registrations for the same
step number
Multiple executional conditioned device test settings can be registered for one
step number.
Note, however, that multiple executional conditioned device test settings with
same device name cannot be registered for the same step number. If this
occurs, the registration data will be overwritten. (Even though the same device
is specified, if the execution timing differs, two settings can be registered for
one step; one for "Before executing instruction" and the other for "After
executing instruction".)
[Debug]
Setting range
Name of a program registered in the CPU module
0 to (Step No. for the END instruction)
Device listed at (2) in this section
Before executing instruction / After executing instruction
Setting range corresponding to each value format
DEC (decimal) / HEX (hexadecimal)
16 bit integer / 32 bit integer / Real number (single
precision) / Real number (Double precision)
D0 D10 D20
Devices that executional conditioned
device test settings can be registered
for the start step of the + instruction.
[Executional conditioned device
6)
7)
For word device