Mitsubishi Q00JCPU User Manual page 578

9
PARAMETERS
Item Parameter No.
Interrupt
counter
start No.
System
interrupt 1008
Fixed scan
setting
interval (n :
28 to 31)
Interrupt program/fixed
1008
scan program setting*1
Module synchronization 100C
(3) PLC file
Item Parameter No.
Initial device value 1102
9
- 4 9.1 PLC Parameters
9.1.1 Basic model QCPU
Table9.2 PLC system setting list (Continued)
Description
Set the start No. of the interrupt
counters.
H
Set the execution intervals of the
interrupt pointers (I28 to 31).
Set whether an interrupt
program is executed at high
H
speed or not.
Set whether a CPU module
startup is synchronized with an
H
intelligent function module
startup.
* 1: The Basic model QCPU does not support fixed scan execution type programs.
St the file used by the CPU module.
Table9.3 PLC file list
Description
Set the device initial value file
H
used by the CPU module.
Setting range
C0 to 13184 (Can be set up to
the number of counter setting
points - 128)
2ms to 1000ms (1ms unit)
Execute at high speed/Do not
execute at high speed
Synchronize/Do not synchronize
with intelligent function module
startup
Figure 9.3 PLC file
Setting range
• Not used
• Use
Default value Reference
No setting Section 10.2.11(4)
I28 : 100ms
I29 : 40ms
Section 10.11
I30 : 20ms
I31 : 10ms
Do not execute at
Section 3.1.3
high speed
Synchronize with
intelligent function ----
module startup
Default value Reference
Not used Section 6.26