Fx 1N Run/Stop Control - Mitsubishi MELSEC-F FX1N-40MT-001 Hardware Manual

FX1N Series Programmable Controllers
3.2 FX RUN/STOP Control
1N
RUN or STOP of the FX
ŒThe RUN/STOP switch mounted next to the programming port.
A standard input (X0 to X17) defined by the system parameters.
ŽRemotely from a personal computer or other programming peripheral.
Note:The FX
refer to the table below.
During remote operation the FX
recently operated control.
E.g. If the RUN/STOP switch is in RUN and a remote STOP is made from a personal
computer the RUN/STOP switch must be switched to STOP then back to RUN to
switch the MPU back to RUN mode.
Run input terminal


S/S 0V
can be controlled by:
1N
RUN/STOP switch works in parallel with the RUN-input terminal. Please
1N
RUN
24V X0
RUN/STOP status is determined by the most
1N
RUN/STOP selection
Œ 
RUN/STOP
SWITCH
ü
ü
û
û
Installation Notes 3.
FX MPU
RUN INPUT
1N
STATUS
TERMINAL
ü RUN
û
RUN
û STOP
ü RUN
3-4