Mitsubishi Q00JCPU User Manual page 415

6
FUNCTIONS
Universal
UD
Note6.43
High
Basic Process
Performance
Note6.44 Note6.44 Note6.44
Redundant
Note6.44
Note45Note46
Note45
When using the sampling trace auto start function in the Universal model QCPU, check the
Universal
UD
versions of CPU module and GX Developer. (
Note6.43
Note46
High
Basic Process
Performance
The Basic model QCPU, High Performance model QCPU, Process CPU, and Redundant CPU
Note6.44 Note6.44 Note6.44
do not support the sampling trace auto start function.
Redundant
Note6.44
2) Executing sampling trace using the auto start function
Check the box for "Auto start" on the Sampling trace setting wizard screen.
When the check box for "Auto start" is checked, sampling trace will be started
automatically at the following timing.
• When the programmable controller is powered OFF
trace setting is completed.
• When the CPU module is switched from STOP to RUN.
POINT
When re-registration of sampling trace setting is attempted by powering OFF
ON the programmable controller, resetting the CPU module or switching the CPU
module from STOP to RUN, the setting is not re-registered regardless of the
status of SM829 (Forced registration specification of trace setting) if a trigger
condition has already been satisfied. In this case, the module is in the status
where the sampling trace setting registration has been canceled, turning SM800
(Trace preparation) OFF.
Figure 6.76 Screen for auto start setting
Appendix 4.5)
6.14 Sampling Trace Function
1
Note6.43,Note6.44
2
3
4
ON after sampling
5
6
7
8
6
- 115