Mitsubishi Q00JCPU User Manual page 80

2
PERFORMANCE SPECIFICATION
Item
Program memory
Memory card (RAM)
Memory
Max. number of
card
files stored
(ROM)
Standard RAM
Standard ROM
No. of times of writing data into the
standard ROM
No. of I/O device points
(No. of points usable on program)
No. of I/O points (No. of points accessible
to the actual I/O module)
Internal relay [M]
Latch relay [L]
Link relay [B]
*6
Timer [T]
*6
Retentive timer [ST]
*6
Counter [C]
*6
Data register [D]
*6
Link register [W]
*6
Annunciator [F]
*6
Edge relay [V]
[R]
File
register
[ZR]
Link special relay [SB]
Link special register [SW]
*5 : Each of parameter, intelligent function module parameter, sequence program, SFC program, device comment, and device initial value
files can be stored.
*6 : The number of points can be changed within the setting range. (
2
- 2 2.1 Basic model QCPU
Table2.1 Performance Specifications
Q00JCPU
Flash card
ATA card
----
256 points
(X/Y0 to FF)
The low- and high-speed timers are specified by the instructions.
The measurement unit of the low- and high-speed timers is set up by parameters.
0 point by default (sharing of the low- and high-speed retentive timers) (changeable)
The low- and high-speed retentive timers are specified by the instructions.
The measurement unit of the low- and high-speed retentive timers is set up by parameters.
(Low-speed retentive timer: 1 to 1000ms, 1ms unit, 100ms by default)
(High-speed retentive timer: 0.1 to 100ms, 0.1ms unit, 10ms by default)
• Normal counter: 512 points by default (C0 to 511) (changeable)
• Interrupt counter: 128 points max. (0 point by default, setting by parameters)
----
----
1024 points (SW0 to 3FF) (The number of device points is fixed)
Basic model QCPU
Q00CPU
Max. 100000 times
2048 points
(X/Y0 to 7FF)
8192 points by default (M0-8191) (changeable)
2048 points by default (L0 to 2047) (changeable)
2048 points by default (B0 to 7FF) (changeable)
512 points by default (T0 to 511) (changeable)
(Sharing of low- and high-speed timers)
(Low-speed timer: 1 to 1000ms, 1ms unit, 100ms by default)
(High-speed timer: 0.1 to 100ms, 0.1ms unit, 10ms by default)
11136 points by default (D0 to 11135) (changeable)
2048 points by default (W0 to 7FF) (changeable)
1024 points by default (F0 to 1023) (changeable)
1024 points by default (V0 to 1023) (changeable)
(The number of device points is fixed)
(The number of device points is fixed)
1024 points (SB0 to 3FF) (The number of device points is fixed)
Section 10.2)
*5
6
----
----
----
1
*5
6
1024 points
(X/Y0 to 3FF)
32768 points (R0 to 32767)/block
65536 points (ZR0 to 65535)
Q01CPU