Mitsubishi Q00JCPU User Manual page 787

12
PROCEDURE FOR WRITING PROGRAM TO CPU
MODULE
12.2 High Performance Model QCPU, Process CPU, Redundant CPU, Universal Model QCPU
2)
Connect the personal computer, which is
installed with GX Developer, to the CPU
module.
Set the RUN/STOP switch to STOP and
the RESET/L.CLR switch to the neutral
position, and power ON the PLC (the
ERR. LED turns on).
Choose [Online] [Format PLC memory]
on GX Deveoper, and format the program
memory.
Choose [Online] [Write to PLC] on GX
Developer, select "Program
memory/device memory", and write the
parameters, created program, etc.
Power the PLC OFF and then ON, or
reset the CPU module.
Set the RUN/STOP switch to the RUN
position to place the PLC in the RUN
status.
3)
* 2 : Refer to the following manual for the procedure when the Redundant CPU is used.
QnPRHCPU User's Manual (Redundant System)
* 3 : When storing the file register and device initial value data into the standard RAM or memory card
(except the Flash card), also format the standard RAM or memory card.
* 4 : Write each data to the following memory.
•Program ..... Program memory
•Parameter ..... Memory set as the parameter-valid drive with the DIP switches
•Device initial value ..... Memory specified in the PLC file setting of the PLC parameter dialog box
* 5 : RUN/STOP/RESET switch for the Universal model QCPU.
12.2.4 Procedure for writing multiple programs
2
3
Write to PLC screen
4
............
2
9
10
11
12
12
- 16