Mitsubishi Q00JCPU User Manual page 948

APPENDICES
TableApp.82 When the parameter-valid drive is set to the memory card (RAM) or memory card (ROM)
Setting in High Performance model QCPU
Boot file setting of PLC parameter
No boot file setting
Contents of boot file setting
Type Transfer from
Program Memory card
(No boot file setting for parameters)
Contents of boot file setting
Type Transfer from
Program Memory card
Parameter Memory card
Contents of boot file setting
Type Transfer from
Program Standard ROM
(No boot file setting for parameters)
Contents of boot file setting
Type Transfer from
Program Standard ROM
Parameter Memory card
App
- 159 Appendix 5 Method of replacing High Performance model QCPU with Universal model QCPU
(b) When the the parameter-valid drive is set to the memory card (RAM) or
memory card (ROM) in the High Performance model QCPU
Change the setting so that the Universal model QCPU can refer to the
parameters in the memory card.
Change the setting so that the Universal model QCPU can refer to the
Transfer to
parameters in the memory card.
Program memory
Transfer to
No changes are required.
Program memory
Program memory
Change the setting so that programs are stored in the program memory in the
first place, instead of booting from the standard ROM.
Transfer to
Program memory
Change the setting so that programs are stored in the program memory in the
first place, instead of booting from the standard ROM.
Transfer to
Program memory
Program memory
Setting in Universal model QCPU
• Changes in parameter setting are not required.
• Delete parameters that exist in the program memory. *2
• Changes in parameter setting are not required.
• Delete parameters that exist in the program memory. *2
• Move the programs targeted for booting from the standard ROM into the
program memory. *1
• Delete all settings for program on the Boot file setting tab of PLC parameter.
• Delete parameters that exist in the program memory. *2
• Move the programs targeted for booting from the standard ROM into the
program memory. *1
• Delete all settings for program on the Boot file setting tab of PLC parameter.
(Continued on next page)