Mitsubishi Q00JCPU User Manual page 635

10
DEVICE EXPLANATION
(6) Annunciator OFF procedure and processing content
Basic
Note10.6
Remark
Note6
Basic
The Basic model QCPU cannot use the LEDR instruction.
Note10.6
(a) Annunciator OFF procedure
The annunciator can be turned OFF by any of the following instructions.
1) RST F instruction
An annunciator No. which has been switched ON by the SET F
can be switched OFF by the RST F
2) LEDR instruction
The LEDR instruction is used to switch OFF the annunciator Nos. stored at
SD62 and SD64.Note6
3) BKRST instruction
The BKRST instruction is used to switch OFF all the annunciator Nos. within a
specified range.
4) OUT F instruction
The OUT F instruction can execute ON/OFF of the annunciator No. by the
same instruction.
However, if an annunciator is switched OFF by the OUT F
"processing at annunciator OFF" ( (6)(b) in this section) is not performed.
Execute the RST F , LEDR or BKRST instructions after the annunciator has
been switched OFF by the OUT F
• When turning OFF annunciator 5 (F5)
Fault detection program
(Annunciator ON program)
Display reset input
• To switch OFF all annunciators which are ON:
Fault detection program
(Annunciator ON program)
Display reset input
Figure 10.13 Example of turning OFF the annunciators
Refer to the following manual for details of each instruction.
QCPU (Q Mode)/QnACPU Programming Manual (Common Instructions)
instruction.
Note10.6
instruction.
RST F5
Program that turns OFF
annunciator 5 (F5)
BKRSTP F0 K10
F0 to F9 OFF program
10.2 Internal User Devices
10.2.5 Annunciator (F)
9
10
instruction
11
12
instruction, the
10
- 20