Mitsubishi Q00JCPU User Manual page 527

7
COMMUNICATION
PORTS OF CPU MODULE
(1) Setting for MC protocol communication
Setting for communication using the MC protocol is described below.
Set the items on the Built-in Ethernet port tab of PLC parameter in GX Developer as
shown below.
(a) Communication data code
(b) Enable online change (FTP, MC protocol)
(c) Open settings
USING
(a)
(b)
Figure 7.18 Built-in Ethernet port tab
Select a communication data code used for the MC protocol, "Binary code" or
"ASCII code".
Check the checkbox to enable online change when writing data to the CPU
module from the external device that communicates using the MC protocol.
For details on the available functions with this setting, refer to (2) in this section.
Set the following items.
• Protocol :
Select a connection used as MC protocol. (Up to 16 CPU modules can be
connected.)
• Open system : Select "MC protocol".
• Host station port No. : Set the host station port number (in hexadecimal).
(Required) (Setting range : 0401
BUILT-IN ETHERNET
Figure 7.19 Open settings screen
to 1387 , 1392
H H
7.4 MC Protocol Communication
(c)
to FFFE )
H H
7
- 13
1
2
3
4
5
6
7
8