11.1.4 Procedure for Boot Operation
This section describes a procedure for boot operation.
In the following procedure,
switch is in RUN, set the switch to STOP.
Select "Do boot from standard ROM." in the
Boot file tab of the PLC parameter dialog box.
and write the parameters and program
Select [Online] [Write to PLC (Flash ROM)]
Power off the programmable controller
and then on or reset the CPU module.
NO
11 - 6
indicates an operation on the CPU module side.
Start
(continued from Section 11.1.3)
If the RUN/STOP/RESET
Select [Online]
[Write to PLC]
to the program memory.
[Write the program memory to ROM)]
and write the program memory data
to the standard ROM.
Is the special relay
(SM660) on?
YES
End
Figure 11.3 Flowchart for boot operation
Section 5.1.5
GX Developer Version 8 Operating Manual