Mitsubishi Q00JCPU User Manual page 949

APPENDICES
TableApp.78 When the parameter-valid drive is set to the memory card (RAM) or memory card (ROM)(Continue)
Setting in High Performance model QCPU
Boot file setting of PLC parameter
Contents of boot file setting
Type Transfer from
(Data other
than program Memory card
and parameter)
Contents of boot file setting
Type Transfer from
(Data other
than program Standard ROM
and parameter)
(Data other than program and parameter indicate initial
device value, device comment, and label program.)
Appendix 5 Method of replacing High Performance model QCPU with Universal model QCPU
Transfer to
Delete all settings for data other than program and parameter in the boot file
Program memory
setting. Since these data can be used even not stored in the program memory,
it is not necessary to transfer them to the program memory. Or, change the
setting so that they are stored in the program memory in the first place.
• Delete all settings for data other than program and parameter on the Boot
Transfer to
file setting tab of PLC parameter.
• Move the data other than program and parameter into the program memory
Program memory
as needed.
* 1: Since the Universal model QCPU retains the data in the program memory even the battery
voltage drops, the boot file setting is not necessary.
* 2: The Universal model QCPU searches for parameters in order of the program memory, memory
card, and the standard ROM, and then uses the parameters found first. If parameters exist in the
program memory or the memory card, the Universal model QCPU cannot use the parameters in
the standard ROM.
Setting in Universal model QCPU
9
10
11
12
App
- 160