Mitsubishi Q00JCPU User Manual page 396

Hide thumbs Also See for Q00JCPU:

Table of Contents

(4) Stop program

Note6.39 Note6.39

Note6.38 Note6.38

6.13 Execution Time Measurement

6.13.1 Program list monitor

Program can be stopped on the program list monitor screen.

Clicking the

Stop program

section) displays the following dialog box.

(a) Program name

Select the program set in the program setting of the PLC parameter dialog box.

A program name cannot be entered as desired.

(b) Stop mode

• Executing "After stop, output stop" for the scan execution type turns off the

output (non-execution processing) at the next scan. The program is put in the

standby status at and after the next scan. (This operation is the same as

performed when the POFF instruction is executed.)

• Executing "After stop, output stop" for the low speed execution type suspends

the execution of the low speed execution type and turns off the output at the

next scan. The program is put in the standby status at and after the next

(This operation is the same as performed when the POFF instruction is

• Executing "After stop, output stop" for the standby program stops the

program after one-scan OFF is executed as scan execution.

For this reason, "Execute count" is also increased by 1.

• "Execute count" is also increased by 1 if an error occurs in the RET/IRET

instruction during execution of one-scan OFF in the standby program.

At this time, the execution type is "scan execution".

In the case of Basic model QCPU, a program cannot be started from the program list monitor

The Redundant CPU and Universal model QCPU does not support low speed execution type

button on the program list monitor screen (

Figure 6.63 Stop program screen

Show Quick Links

Table of Contents