Mitsubishi Q00JCPU User Manual page 721

10
DEVICE EXPLANATION
(5) Universal model QCPU
Table10.26 Interrupt pointer No. and interrupt factor list (Universal model QCPU)
I No. Interrupt Factors
I0
I1
I2
I3
I4
I5
I6
Interrupt
I7
I8
module (QI60)
I9
I10
I11
I12
I13
I14
I15
I16 to
--
I27
*4
I28
*4
I29
*1
Internal timer
*4
I30
*4
I31
Priority
I No.
Ranking
1st point 6
2nd point 7
3rd point 8
4th point 9
5th point 10
6th point 11
7th point 12
I32 to
8th point 13
44
9th point 14
10th point 15
11th point 16
12th point 17
13th point 18
14th point 19
15th point 20
16th point 21
I45
I46 to
49
Empty --
I50 to
255
100ms 5
40ms 4
20ms 3
10ms 2
* 1 : The time-out period of the internal timer is a default value. It can be changed in 0.5ms units within
the range 0.5ms to 1000ms in the PLC system setting of the PLC parameter dialog box.
* 2 : Available for the Multiple CPU system using the QnUCPU.
* 3: Setting for the "Intelligent function module setting (Interrupt pointer setting)" on the PLC system
setting tab of PLC parameter is required to use interrupts from intelligent function modules. (Refer
to Section 6.23 for details on interrupts from intelligent function modules.)
* 4 : Among I50 to 255, I50 has the highest priority (Priority order: 22), and I255 has the lowest priority
(Priority order: 227).
* 5 : When an interrupt occurs, CAN'T EXECUTE(I) (error code:4220) does not occur even though no
interrupt pointer exists in the program.
10.11.1 List of interrupt pointer Nos and interrupt factors
Interrupt Factors
--
Multiple CPU
*2*4
synchronization
--
Intelligent
Specifies which intelligent
function module
function module is used with
*3*5
/Interrupt
parameters.
module (QI60)
10.11 Interrupt pointer (I)
Priority
Ranking
Empty --
0.88ms 1
Empty --
22 to
227
10
- 106
9
10
11
12