Procedure For Writing One Program - Mitsubishi Q00JCPU User Manual

12
PROCEDURE FOR WRITING PROGRAM TO CPU
MODULE

12.2.3 Procedure for writing one program

This section explains the procedure for writing the parameters and program created by GX
Developer to the High Performance model QCPU, Process CPU, Redundant CPU or
Universal model QCPU.
This section explains the procedure for writing a program to the program memory
Universal (
UD
When storing the program into the standard ROM
Note12.1
boot run, perform the procedure given in this section, and then carry out the procedure
given in Section 12.2.5.
In the following procedure,
indicates that on the High Performance model QCPU, Process CPU, Redundant CPU or
Universal model QCPU side.
Universal
UD
Note12.1
12
- 11 12.2 High Performance Model QCPU, Process CPU, Redundant CPU, Universal Model QCPU
12.2.3 Procedure for writing one program
Section 5.2.2).
Start
Start GX Developer.
Set the project.
Do you
NO
change the number
of device points
used?
YES
Change the number of device points in
device setting of PLC parameter.
Create a program to be executed in the
CPU module.
1)
The Universal model QCPU cannot boot data from the standard ROM to the program memory.
( Section 5.2.3)
Note12.1
indicates the operation on the GX Developer side, and
GX Developer Operating Manual
Section 10.2
Ladder (write) screen
............
or memory card and executing