Mitsubishi Q00JCPU User Manual page 701

10
DEVICE EXPLANATION
(3) Setting method
Set corresponding
memory, file name,
and capacity.
Item
"Use the following file."
Since the extended data register (D) and extended link register (W) use the file
register area, settings for both file register and device are required.
(a) File register setting
Select the "Use the following file." item at File register on the PLC file tab of PLC
parameter in GX Developer and set the items in Table 10.17. Do not select the
"Use the same file name as the program." item.
Figure 10.79 Screen for setting the number of points for the file register
Table10.17 File register setting items
Corresponding memory
Memory card (RAM)
Memory card (ROM)
Q02UCPU
Q03UDCPU, Q03UDECPU
Q04UDHCPU, Q04UDEHCPU
Standard RAM
Q06UDHCPU, Q06UDEHCPU
Q13UDHCPU, Q13UDEHCPU
Q26UDHCPU, Q26UDEHCPU
* 1: The capacity is the total number of points for the file register (ZR), extended data register (D), and
extended link register (W).
* 2: The capacity indicates the maximum number of points when SRAM card (8M bytes) is used.
* 3: The capacity indicates the maximum number of points when Flash card (4M bytes) is used.
10.8 Extended Data Register (D) and Extended Link Register (W)
*1
File name
Capacity
*2
Any
1 to 4086k points
*3
Any
1 to 2039k points
1 to 64k points
1 to 96k points
1 to 128k points
Any
1 to 384k points
1 to 512k points
1 to 640k points
9
10
11
12
Remarks
--
Read only
--
10
- 86