Procedure For Writing Multiple Programs - Mitsubishi Q00JCPU User Manual

12
PROCEDURE FOR WRITING PROGRAM TO CPU
MODULE

12.2.4 Procedure for writing multiple programs

This section explains the procedure for writing the parameters and multiple programs
created by GX Developer to the High Performance model QCPU, Process CPU,
Redundant CPU or Universal model QCPU.
This section explains the procedure for writing the programs to the program memory
(
When storing the programs into the standard ROM
Universal
boot run, perform the procedure given in this section, and then carry out the procedure
UD
given in Section
Note12.2
In the following procedure,
indicates that on the High Performance model QCPU, Process CPU, Redundant CPU or
Universal model QCPU side.
Note1
The Universal model QCPU cannot boot data from the standard ROM to the program memory.
Universal
UD
(
Note12.2
12.2 High Performance Model QCPU, Process CPU, Redundant CPU, Universal Model QCPU
Section 5.2.2).
12.2.5.Note1
indicates the operation on the GX Developer side, and
Start
Start GX Developer.
Set the project.
Do you
NO
change the number
of device points
used?
YES
Change the number of device points in
device setting of PLC parameter.
Create a program to be executed in the
CPU module.
1)
Section 5.2.3)
12.2.4 Procedure for writing multiple programs
Note12.2
or memory card and executing
GX Developer Operating Manual
Section 10.2
Ladder (write) screen
............
9
10
11
12
12
- 14